TwistOut™ makes the removal of rounded and damaged nuts and bolts easier than ever. Operates on a patented* design that grasps even the most rounded of fasteners - even bolt studs. The trick is in the reverse spiral teeth located on the inside of the socket walls. These spiral teeth work to grab the damaged fastener and dig in until the fastener is freed.

Features:
• Patented reverse cold-formed spiral design digs in to remove stubborn fasteners
• Hardened alloy 51 Rc to remove up to No. 8 hardened bolts and nuts
• Use with a 3/8" or 1/2" drive ratchet or a wrench

Instructions:
Step 1: Place the remover over the damaged nut or bolt. One quarter of the damaged fastener should be covered by the remover. A brass hammer or mallet may need to be used to ensure the socket is firmly seated. Some additional rounding of the fastener may be required to allow the socket to fully grasp it. This may be accomplished with the use of pliers or a file.
Step 2: Place ratchet or wrench on socket and remove damaged nut or bolt.